Forehand counter loop from near the table

Strokes and Technique

aahel Guha
aahel Guha Asked 11 years ago

Hi!Alois, how do i play a forehand counter loop from near the table?  i am able to do the stroke from the back of the table,but fail to execute the stroke consistently from near the table.  Most of the better players like ma long and zhang jike are very good at this stroke but i am finding it quite difficult in making the stroke quick enough and with the proper timing from near the table. would be glad if you could help me out.Thanks!


Alois Rosario
Alois Rosario Answered 11 years ago

Hi Aahel,

This is a very advanced stroke.  The top players may make it look like a simple stroke but in fact it is very difficult.

Start with just putting a little topspin on your block and then build it up from there.  Each time try to put a little more topspin on the ball.  You stroke will start quite small and start to increase the swing slightly and also the brushing contact.  However you don't have a lot of time.  Therefore to make this stroke, even on the full topspin stroke you don't need such a big swing because the ball already has a lot of spin and speed so just use that to counter topspin the ball.


Thoughts on this question


aahel Guha

aahel Guha Posted 11 years ago

i am just not getting enough brushing on the ball when it is coming at that speed.hence most of the balls are going long.is this due to my rubber or does my stroke need improvement?


Alois Rosario

Alois Rosario from PingSkills Posted 11 years ago

What type of rubber are you using?  Spin is important to get the ball down quickly.


aahel Guha

aahel Guha Posted 11 years ago

i am using the yasaka mark v

 


Alois Rosario

Alois Rosario from PingSkills Posted 11 years ago

That should be OK to make the shot.  Focus on brushing the ball better on contact. Even if you hit the ball slower.


Abhiram Reddy

Abhiram Reddy Posted 11 years ago

so substandard rubber does not produce enough spin to loop it back on to the table . no wonder my close to the table slow loops do not land no matter how much spin i put andslowly the ball travels they overshoot the edge !!!!


Become a free member to post a comment about this question.